17403
26/07/2021
16300
29/07/2021

20001

TRANSFER MACHINE FOR SHOE METAL TIPS

Home » Machines » 20001

The composition of the line provides in the first position a 2 t decoiler and immediately after it there si a pneumatic feeder which supplies the material to the 100 t press, where both the actual drawing uint and the cutting-off, trimming and flanging units are housed.

TECHNICAL DATA

Decoiler capacity: 2 t
Press force: 100 t
Production capacity: 15  tips/min

MACHINE CONFIGURATION

  • DECOILER 2 t

    It is a motorized decoiler (or idle on request) with the capacity of 2 tons. Complete with hydraulic power pack and independent electric plant. Hydraulic unit for the spindle regulation, an electric plant for the automatic / manual mode and for the speed regulation. Complete with loop, arm for the loop control, and spokes to maintain the strip in the correct position.

    TECHNICAL DATA

    Decoiler capacity 5 ton
    Shaft diameter (min/max) 470/530 mm
    Coil max. external diameter 1800 mm
    Motorized AC decoiler with inverter 4 kW
    Decoiler opening hydraulic  
  • PNEUMATIC FEEDER

  • INCLINED HYDRAULIC PRESS 100 t

  • DIE HOLDER FOR DRAWING UNIT

  • DRAWING UNIT

    Die-holder for trimming, separation and flanging with blank holder below.

  • CUTTING-OFF AND TRIMMING KIT

    Kit for cutting-off, trimming and flanging

  • CONTROL PANEL AND ELECTRICAL INSTALLATION

    The whole electric installation is intended here. Electric cabinet, cable channels, control desk and software for the management of the line parameters, all according to the highest standards of quality and efficiency.

Se desideri ricevere maggiori informazioni



I nostri consulenti commerciali saranno lieti di offrirvi una consulenza personalizzata.